Beogram 4000 acrylic dust cover / lid


SKU: DC-003 Categories: ,


New dustcover for Bang & Olufsen Beogram 4000.

This is the “light brown-ish grey”-color acrylic part of the dust cover with readily fitted rubber bumpers for the front corners.

This is a direct replacement for original Bang & Olufsen part # 3164113 (part of complete dustcover assembly 3164121).
After part# 3164113 was discontinued from Bang & Olufsen, it was for a period of time replaced by 3164184, but whereas the color of 3164184 is correct for Beogram 4002, 4004, 6000, it was wrong (too dark) for Beogram 4000.
This new dust cover is correct color for Beogram 4000.

Comes with new screws and fiber washers.
Don’t reuse the original screws. Use only the screws and washers included with the new dustcover.

Manufactured by Beoparts-shop.

Note: Screws should not be VERY tight. Tighten until screws start to “bite” and add an eighth (1/8) of a turn. No more.

Note: This product was cast (injection molded) in one piece. It has no glued seams.
Very slight weld lines from the molding process (also found on original parts) could be visible under certain light conditions and should be accepted.

Note: For cleaning this product use only a soft cloth. If very dirty use handwarm water and dishwasher liquid.
Never use any solvents (acetone, ethanol, gasoline etc.) when cleaning this product.

Note: Original hoods are not all entirely identical. They vary slightly, presumably because different molds were used over the original production years.
Variations in hood width of up to +/-1mm have been noted. It therefore cannot be completely guaranteed that the original aluminium trim strip will be an exact fit when transferred directly from the original hood to the new.


Additional information

Weight 1,501 kg